Fire pump fluid isn't enough, the fire pump can't operate, then's the reason

In the case of ministry and outfit, the whole operation depends on a number of details to complete together, if one of the small fast content of the problem, also, it's possible to stop the operation. In the case of the fire pump, the fire pump will also stop operating when the liquid isn't enough. So, what's the principle of it? I will talk to you about the reasons.

Fire pump liquid isn't enough, the reason why the fire pump will be touched off to stop operating, among others, because of the following points.
1, the fire pump liquid isn't enough, the fire pump isn't filled with water, or no proper exhaust
2, the fire pump liquid isn't enough, the operation speed of the fire pump is too low
3, the fire pump liquid isn't enough, may be because the suction range is too high, can't be transported, fairly speaking, the liquid isn't enough to drive the operation
4, the fire pump liquid isn't enough, may be because the fire pump impeller channel is blocked
5, the fire pump liquid isn't enough, may be because the gyration direction is wrong
6 、 inadequate liquid of fire pump may be due to air generation or bay channel leakage and other problems.
7 、 inadequate liquid of fire pump may be because the size of nethermost stopcock ofanti-pump is too small.
8, the fire pump liquid isn't enough, may be because the gap between the impeller of the fire pump is too large.

The below 8 conditions are the main reasons for the lack of liquid in the fire pump, and once the liquid in the fire pump is inadequate, the fire pump operation will be subject to idleness. For this reason, when we use the fire pump every day, on the one hand, we should pay attention to the correct operation, on the other hand, we also need to do a good job of preventative conservation, always pay attention to the bad symptoms shown by the fire pump, for effective enhancement.

Fire pump liquid deficit is one of the main common failures of fire pumps, we can't take it smoothly!